Oven Door Won’t Open: Troubleshooting Door Lock Problems on a Range Video

Lock Stuck After Self-Cleaning Cycle

Hi, this is Wayne from Sears PartsDirect. Today we’re going to talk about an oven with a malfunctioning door lock. You’re probably watching this because your oven door is stuck shut. Let me guess, did you just run a self-cleaning cycle?

cf8fd1e1-f6aa-4713-911f-eccbfa209d14_1.5928a6ef96dceda1963aebfbd05510f8

During the cleaning cycle, your door will lock for safety purposes. Under normal circumstances, the door won’t unlock until the oven has cooled to room temperature. The thing is, if you lose or disconnect power before the cycle is finished, the lock motor may not complete the cycle to unlock the door. We’ll show you how to reset the lock and get things working.

Get the Door Open

But, the lock motor itself could be broken. So we’ll also show you how to test that out while you’re back there. Now that it’s stuck shut, let me show you how you can get it open fast and get back to cooking.

Pull the range out from the wall and disconnect the power. Remove the back panel to gain access to the lock motor assembly. Remove the screws holding the door lock assembly in place. Release the door-latching rod by pulling the lock motor assembly down and tilt the front inwards. This will allow you to unhook the locking rod from the drive cam.

Push the rod forward and open the oven door. Note the position of the drive cam and the hole that the locking rod fits into. Remove the Philips screw holding the drive cam on the motor. Remove the drive cam and rotate it 180 degrees from where it was when the door was locked.

Line up the two slots on the bottom of the drive cam with the posts on the motor shaft. Push the drive cam down and lock it on the motor shaft. Make sure that the switch arm aligns with the side edge of the drive cam. Reinstall the Phillips screw on the cam.

Re-hook the locking rod back onto the drive cam. Install the motor bracket assembly back onto the range. Now, you can put everything back together, and at least be able to cook again.

Test the Door Lock

But if you’ve got a bad door lock, your door is going to get stuck again the next time you run a cleaning cycle. We’ll check the lock motor circuit for electrical continuity with a multi-meter while we’ve got this back panel off. Always disconnect power before checking continuity. Locate the two electrical wires going to the lock motor and disconnect them.

Set your meter to read ohms of resistance on the 20,000 ohms scale. Place one meter lead on each terminal of the lock motor. If you measure no continuity, on this meter that’s a “1” on the far left corner, then the door lock is bad and will need to be replaced.

Original Article here: Oven Door Won’t Open: Troubleshooting Door Lock Problems on a Range Video

Related Video here: Why is My Oven Door Locked?

If you want someone that could help you with your door lock problem, Locksmith Vinings GA is here to help you!

Advertisements